![The Doors: Mr. Mojo Risin': The Story of L.A. Woman [Blu-Ray]](http://ecx.images-amazon.com/images/I/51n6Ow52M2L._SL160_SS160_.jpg)
Welcome to Doors Guide
Love Her Madly Doors Article
. For a permanent link to this article, or to bookmark it for further reading, click here.
8. How to Apply Door Casing
from:Appling a new door casing to finish out a new room or re-finish an existing room is easy and can change a room’s appearance. If replacing an old casing, carefully remove and discard the old material.
To install a new casing, you must measure for the inside of the door frame, on the wood casing, and make a mark a 1/8” from the inside all around the door frame. This is to give the finished door a 1/8” reveal between the door and the casing. Now measuring from this 1/8” mark on the top to the floor; record this and transfer this measurement to your new casing, it is always good to measure twice and cut once. Remember this will be the shortest point on the casing when cutting the 45 degree angle, so it is best to mark the inside edge of the casing. Using either a hand or power miter box, cut at the mark at 45 degrees. NOTE: It is best to cut the opposite end first to make sure it is nice and square before making the finished measurement. After this is cut, measure across the top and only cut the 45 end that will mate with the first piece. This is to align the two pieces without nailing them, just in case the angle is not exactly 45 degree. Dry fit the two pieces to make sure you have a tight mitered corner and adjust as needed, then re-measure and cut the opposite end of the top casing.
When the miters appear to be tight, apply some wood glue to the surfaces of the mitered ends, and nail the casings to the jambs using 4D (4 penny) nails at least 1 inch back from the miter. You may want to drill pilot holes for the nails before nailing, to avoid splitting the wood. Measure and cut the last side, if you have any scrap pieces, you can cut the 45 degree angle and test to make sure the miter is again tight, and adjust the angle cut as needed to cut the final piece. To make sure the corner miters remain tight, carefully nail from the top piece of casing down into the side casing. It would be best to pre-drill and take care so you do not split the casing in the corner. Repeat this from the side of the casing nailing into the top casing.
When one corner is complete, repeat for other corner, when it is completely hung. Nail the last side in place with wood glue on the mitered surfaces, again using 4D nails. Use a nail set and hammer to set the nails slightly below the finished surface. If you are painting, use a filling compound such as Spackle to fill the nail hole. If you are staining, use a wood filler appropriate to your finishing technique.
Love Her Madly Doors News
Rock Music Menu: The Doors' 'LA Woman' turns 40 - Delaware County Daily Times
Rock Music Menu: The Doors' 'LA Woman' turns 40 Delaware County Daily Times “Been Down So Long,” “Car Hiss By My Window” swell with the genre's influence, and even the better known tracks like “Riders on the Storm” and “Love Her Madly” make sly nods toward it. Last November, The Doors unveiled a limited edition, ... |
“I Love My Man & Want A Life With Him, But His Baby Momma Won't Move On!” - Vibe
“I Love My Man & Want A Life With Him, But His Baby Momma Won't Move On!” Vibe We are madly in love with each other, and do everything that committed couples do. He told me plenty of times that he loves me, and shows me too, so I know that it's real. I decided to move in with him about 3 months ago, and have been living with him ... |
Aide: Edwards said mistress was 'crazy' - HLNtv.com
 PerezHilton.com | Aide: Edwards said mistress was 'crazy' HLNtv.com ... knocked on his hotel door in early 2007 and proclaimed that “she and John Edwards were madly in love.” Edwards is on trial for allegedly spending almost $1 million in campaign funds to hide Hunter and her pregnancy during his 2008 presidential run. John Edwards' Mistress Confessed To Campaign Aide That They Were 'Madly In Love' Rielle Hunter: John Edwards' mistress yet to appear at trial, but her ... John Edwards trial: Mistress told aide she and Edwards were 'madly in love' |
Profile-Cyprus' most famous chef - Cyprus Mail
 Cyprus Mail | Profile-Cyprus' most famous chef Cyprus Mail I meet you in this job,” he explains with a touch of exasperation, rattling off the problem like a puzzled outsider, “I fall in love with you in this job, we have a relationship together for one, two years – still in this job – you know my hours and ... |
Ron Tanner turned a condemned frat house into a historic treasure - Charleston City Paper
Ron Tanner turned a condemned frat house into a historic treasure Charleston City Paper "I was madly in love with her, and because she wanted the house, I said OK," Tanner says. "She said she'd help me work on it. She didn't say she'd move in, but I assumed that if we worked on it together, she'd move in, we'd get married, ... |