![The Doors: Mr. Mojo Risin': The Story of L.A. Woman [Blu-Ray]](http://ecx.images-amazon.com/images/I/51n6Ow52M2L._SL160_SS160_.jpg)
Welcome to Doors Guide
Arched Top Exterior Doors Article
. For a permanent link to this article, or to bookmark it for further reading, click here.
6. Painting Doors
from:Painting a door can change the look of an interior room or the exterior appearance, without a lot or remodelling or construction mess.
Interior doors previously stained or polyurethane will need to be sanded to remove any sheen from the existing surface. Before sanding, protect the room and floor with a drop cloth or painter’s tarp to collect any dust and paint drops. It would be a good time to remove the door knob and lockset if one is present, before sanding, and to make painting that much easier. After the door is sanded and cleaned, a good primer will be needed to make sure the old stain will not ‘bleed’ through the new finish. Following the grain of the wood, keeping a good ‘wet’ edge of paint, prime the entire surface. If both sides are to be painted, it is best to leave the door on the hinges and swung half way open to get access to both sides of the door. If only one side is to be painted, for a good finished job, it would be best to remove the door and lay it flat on some saw horses.
With the door removed, removing the hinges would be recommended, for a clean finish as well.
With the primer coat finished and dry, apply the finish coat of paint, again, nice long even strokes following the wood grain. If needed, a second coat may be required if the original colour was a lot darker then the new finish. After the paint has completely cured, apply the hinges, if removed, and re-hang the door. After that, put the doorknob and lockset back on.
Exterior doors will need either a good exterior grade paint or, if stained or left ‘clear’, a good exterior polyurethane or lacquer should be used. If brushing on paint, follow the steps used in painting an interior door, removing all hardware and cleaning the surface properly. When staining or leaving the door ‘clear’, if the door was previously painted, the door must be sanded to bare wood again. Apply the stain with a rag, and after 10 minutes wipe off the excess. This is done to allow the wood to absorb the stain evenly.
After the stain is completely dry, apply a polyurethane or lacquer with a good brush and long even strokes, following the wood grain again. The trick here is to apply a few thin coats to avoid drips and runs, as this finish will be thinner than paint. When the final finish is complete, put all the door hardware back on.
Arched Top Exterior Doors News
Resale of the week: Expanded 1931 catalog house in McLean
When prospective homebuyers make a wish list, they don't often include an observatory as a top priority, but having one in your backyard certainly could be fun. The home at 1826 Great Falls St. in McLean, on the market for $965,000, has an observatory and plenty of fun features that ...
Read more...Landmark Society announces preservation and restoration awards for 2012
This post has been updated with the write-up for the Griffen home. Press release: The Landmark Society of Genesee County will hold its annual Preservation Awards Dinner on May 19 at the St. James Episcopal Church ((405 E. Main St., Batavia). The dinner will begin at 6 p.m. and the awards presentation will follow (at approximately 7 p.m.). Six buildings in Genesee County will be recognized this ...
Read more...Wellesley Home of the Week: 2 Lafayette Circle
This three-bedroom, two-bathroom colonial at 2 Lafayette Circle embraces the grace of halcyon days with its early 20th-century details yet also fulfills the needs of a modern family through clean lines from many updates and renovations and spacious rooms.
Read more...Muslims open mosque to Quad-City community
Water bubbles up from a fountain next to the front entrance of the new mosque for the Muslim Community of the Quad-Cities in Bettendorf.
Read more...